“Wrinkly Pig” Corset Case Study

This entry is a summary of the review video “Wrinkly Pig” Corset Case Study”. If you would like more complete information and side notes about the corset, you can watch the video on YouTube here:


Note: the following are the differences between the “Wrinkly Pig” and the “Tickled Pink” corset in terms of construction:

  Wrinkly Pig Tickled Pink
Fusing Fused the brocade to a layer of woven fusible interfacing, then flatlined that to coutil. Fused the brocade directly to a layer of coutil using “Heat n’ Bond” (fiddly sheet of glue, I don’t recommend it).
Roll-pinning Everything was flat-pinned, not roll-pinned. Some roll-pinning was done on the side panels.
Seams Lock-stitched seams; allowances were not trimmed or clipped at curves. Seams were trimmed and flat-felled.
Boning channels Double-boned at the seams, sandwiched between two layers of coutil. Single boned at the seams, used external boning channels (cuts down on wrinkles slightly)


And here is my review:

Fit, length Decent curves. Used to be a slightly long-line corset but I later shortened the hips so it is more of a cincher now. Center front is about 11″ long.
Material 4 layers including the interfacing: brocade fashion fabric fused to interfacing, then flatlined to interlining of coutil and another lining of coutil.
Construction 6-panel pattern. Seams were lock-stitched (stitched twice) at the seams, the allowances were pressed open. The brocade/interfacing/coutil flatlined panels were all assembled, then the coutil lining was assembled. The layers were then stitched together at first/last panels, flipped right-side out and stitched in the ditch between panels and also secured at boning channels.  Bones are sandwiched between the two layers of coutil.
Binding The binding at top and bottom are made out of commercial hot pink cotton bias tape, machine stitched on both sides.
Waist tape 1” wide twill tape between the coutil lining and interlining, stitched invisibly so it’s not noticeable.
Modesty panel Suspended modesty panel made from brocade fused to twill, and stiffened with plastic canvas. 7″ wide.
Busk A standard flexible busk, 1/2” wide on each side, with 5 pins, 9.5″ long.
Boning 22 steel bones in this corset not including the busk. The seams between the panels are double-boned (except the seam closest to the grommets with ¼” inch wide spirals, and there are a pair of flats sandwiching each column of grommets.
Grommets There are 30 2-part size #X00 eyelets (15 on each side). They have a medium flange around and are spaced out 3/4 inches apart. No pulling away of fabric yet but they are very small so many types of fat cord is hard to thread through.
Laces 1/2″ wide double-face satin ribbon, baby pink in colour. About 5 meters and not really long enough for my tastes. I think I may change out the laces for some longer ones.
Price If I were to re-make this corset, I would roll-pin the panels and also use wonder-under or stitch-witchery to directly fuse the brocade to a layer of coutil to eliminate wrinkling. Keeping other construction techniques the same, I would likely charge around $260 USD for a corset like this.

Leave a comment

Leave a Reply

Your email address will not be published. Required fields are marked *

%d bloggers like this: