This entry is a summary of my videos for the Princess Tamina costume. If you would like more information and side notes about the corset and costume, you can watch the videos on YouTube here:
| Fit, length | Self-drafted underbust corset with a peaked front top and bottom edge. Stops just at the hips, and features a high back (7″ above waist). Made to close at 21″ at the waist. I took 3 horizontal measurements and 5 vertical measurements to draft this. |
| Material | 4 layers of material; fashion fabric is a very stretchy gold-on-beige lamé, two layers of down-proof cotton ticking (labelled “coutil” in French) as strength layer, and ivory satin lining. |
| Construction | Drafted from a 5-panel pattern. Lining was flatlined to ticking and lockstitched between the seams, then joined to another layer of ticking (wrong sides together) via the sandwich method. Sandwiched boning channels were sewn through those 3 layers, then the fashion fabric was redesigned to look like a ribbon corset and was tacked down at center front and back seams; floating in all other places. Embellishment was hand-sewn. |
| Binding | Made from bias strips of lamé and machine stitched on both front and back. Back of binding was not folded under but left raw; as it’s a knit it doesn’t fray. |
| Waist tape | 1-inch wide waist tape, invisibly stitched between the two layers of ticking. |
| Modesty panel | None. |
| Busk | None; closed front. |
| Boning | Only 12 bones including center front; all half-inch wide steels. Two at center front and one on each seam between panels; only a bone on the outer edge of the grommets, not the inner edge. |
| Grommets | There are 22, 2-part size #X00 grommets (11 on each side), finished in gold to match the rest of the corset. This corset being the first time I hammered in grommets, the back of some of them are rough and catch a bit on the laces. |
| Laces | Round nylon utility cord made for outdoor/sports use. It was loosely woven, frayed easily, slippery and didn’t hold bows very well. |
| Price | The cost for materials was close to $70 because the only store that supplied steel bones near me charged me an arm and a leg for them. Otherwise this corset would have been closer to $35-$40 in supplies. If I were to remake this corset today and sell it, it would cost around $315 USD. ($225 underbust corset + $15 half-inch boning upgrade (I’d use spiral at seams) + $20 double (proper) coutil strength layer upgrade + $40 pattern modification + $15 hand-sewn embellishments) |
