Posted on

Review of “Oriental Princess” Ensemble – Serinde Corsets

This post is a summary of the “Serindë “Oriental Princess” Corset Outfit review” video, which you can watch on Youtube if you prefer:


Fit, length Center front is 10 inches long, the shortest part of the corset at the side seam is 7.5 inches (cut very high over the hip), and the enter back is also 11.5 inches. Circumferential measurements: waist is 24″, ribcage 26″ (measured about 3 inches above the waist), high hip 32″. The silhouette is very mild in silhouette; gently curved in the waist.
Material Fashion fabric is red brocade, the strength layer is coutil, and the lining is a lightweight black cotton.
Construction 6 panel pattern. Fashion fabric and strength fabric were flatlined, panels assembled with a top-stich, and it’s double-boned on the seams. Floating liner.
Binding Red taffeta which matches the rest of the ensemble (halter and skirt), machine stitched on outside and hand-finished inside. Gold-tone beads and coins also attached by hand every inch or so around the top and bottom edges.
Waist tape 1 inch wide twill waist tape, invisibly stitched between the layers.
Modesty panel Modesty panel is around 5″ wide, finished in the same fashion fabric (red brocade and black lining). Stiffened with 2 steel bones (criss-crossed on the panel) and suspended on the laces. There is also a 1/2″ wide modesty placket in the front by the busk.
Busk 9 inches long with 5 pins, last two closer together. Standard flexible busk (half inch on each side). Finished in a gold-tone.
Boning 26 total bones not including busk. 1/4″ wide spirals, double boned on the seams. Two further 1/4″ wide flats sandwich the grommets on each side, as well as one 1/4″ flat steel by the busk on each side, making a total of 13 bones on each side.
Grommets Size 5mm Prym eyelets (very good 2-part eyelets and washers) with medium flange, finished in gold to match the rest of the hardware. Set a little closer at the waistline for ease of cinching. They’ve all rolled nicely.
Laces 1/2″ red double faced satin ribbon. Zero spring. They glide well through the laces.
"Oriental Princess" ensemble made by Serinde Corsets. Modelled by myself (Lucia Corsetti), photo by Remedy Photography.
“Oriental Princess” ensemble made by Serinde Corsets. Modelled by myself (Lucia Corsetti), photo by Remedy Photography.

If memory serves correctly, this is the first time that I’m reviewing an entire outfit / ensemble, as opposed to simply a corset – I’m very fortunate that this fit well enough to review even though it wasn’t made to my measurements. This outfit was originally called “The Oriental Princess” by Serinde Corsets.

The halter is directly sewn onto the top edge of the corset, and they can be adjusted with ties in the back of the neck. There is enough curve to conceivably give enough room for even quite large cup sizes, but it can also be pulled very tightly to fit smaller cups.

The mermaid skirt is also in a matching taffeta-texture fabric, with hand-sewn gold beads set approximately knee-level. This skirt is unfortunately just a little short for me, as it was made for a model a bit shorter than I am, but if I wear the outfit in flat slippers it’s not too noticeable. The back of the skirt is a little longer than the front – not a train per se, but it flares out beautifully behind me when worn. 

Lastly, the lace shawl was ingeniously created from a simple tube of lace fabric, and again gold-tone beads were fastened on the edge of the “sleeves” and scattered throughout as well.

Serinde is currently on hiatus from commissions, but you can visit her Facebook fanpage here.