How to Attach Garter Straps (Suspenders) to Your Corset
I recently received an email from a client who had purchased a corset and garter straps (suspenders) from my shop. They had assumed that when they’re purchased together, they would come attached, but in reality the garter straps are detachable and interchangeable (which means you can use them in many of your corsets!) but it does mean that there is “some assembly required.”
Most brands of corsets come with garter tabs, which are small loops at the bottom edge of the corset – they’re usually sewn upwards so that when they’re not in use, they are out of the way and not visible from the outside. They are also pressed very flat so as not to irritate your skin in any way.
When you do want to attach your garter straps to the corset, you take the “hook” side (it looks just like the hooks that come with interchangeable bra straps) and slide it through the garter loops.
Make sure that you’re not attaching your garter strap inside out! There’s an inside and an outside. The outside has the metal slider which allows you to adjust the length of the strap. You will also see that the “button” part of the garter clip faces outwards, for ease of use and to prevent your skin from touching the metal wire loop.
Check out the video below to see how to attach your garter straps to your corset. It’s much easier to do this before you put on the corset as opposed to when you’re wearing the corset.
You can also adjust the length of the garter strap (if it’s your first time attaching your stockings and you’re not sure how taut you need the straps to be, it might be easier to lengthen the garter straps as far as they will go when you attach to your stockings, and then tighten to your preferred amount once everything is attached.
To adjust the length of your garter straps:
- Flip up the metal slider to unlock it – this helps it glide easier.
- To lengthen the strap, grab the upper portion (with the single layer of elastic) while pulling down gently on the slider, allowing the lower portion (the double-layer loop of elastic) to glide freely. This makes a smaller loop, lengthening the strap.
- To shorten the strap, pull up on the metal slider with one hand and you may also need to pull gently on the loop of elastic below the slider as well, if there is tension on the strap from your corset being attached to your stockings. The aim is to make that loop bigger, which shortens the strap.
- Once you’re happy with the length, remember to flip down the metal slider – this makes the “teeth” of the slider bite into the elastic, keeping it in place!
My corset has 6 garter loops, but I only have 4 garter straps!
This can happen if you ordered your corset from a different shop as your garters, or if you lost a couple of garter straps – but not to worry! You can still use your straps.
There are 3 garter tabs on each side of your corset – I would recommend attaching your straps to the first one (closest to the front busk) and the last one (closest to the back laces), leaving the side seam without a strap.
Or – if you have a bigger bum, or if your garters just don’t like to stay attached at the back of your stockings when you sit down or stoop, you can attach your straps to loop 1 (by the busk) and 2 (on the side seam) and leave the back unsupported. This does mean that your stockings might sag a little at the back, but if your skirt / slacks are long enough, this won’t be visually noticeable.
My corset has only 4 garter loops, but I have 6 garter straps!
Keep those extra two garter straps for backup in case you lose a couple. ;)