Corsets-UK ‘Waist Taming’ Overbust Review
This entry is a summary of the review video for the “Waist Taming overbust with Hip Panels and Curved Hem” by Corsets-UK. If you would like more complete information and side notes about the corset, you can watch the video on YouTube here:
|Fit, length||Center front is 14 inches long, princess seam is 16 inches, the side seam 12.5 inches and the center back is 14 inches long. (Fits a bit short on my long torso and low waist.)
Bust spring is 9″, rib spring is 4″, hip spring is 9″. Has rounded hips and a relatively conical ribcage.
|Material||The fashion fabric is polyester based satin, and the lining is cotton twill.|
|Construction||6-panel pattern (14 panels total). 6 panels are “full length”, while the 7th panel is the semi-circular hip panel. The layers were flatlined and panels assembled, and boning channels cover the seam allowances on the lining side.|
|Waist tape||Partial waist tape, exposed on the lining side. Starts at panel 2 and stops at panel 5. One inch wide, made from black cotton twill tape. The tape is positioned a bit too high on my body (about 2 inches above my natural waist) so it sits on my lower ribs.|
|Binding||Binding at top and bottom are made from matching black satin. Machine stitched on both sides on a single pass (likely using a specialized binding attachment on the sewing machine). 6 garter tabs (3 on each side) and additionally there are 2 small tabs per side on the top edge if you want to add your own bra straps.|
|Modesty panel||There is a modesty panel on the back, made of two layers (satin on the outside and twill on the inside). 7.5” wide and unstiffened. It’s sewn into the corset (covered by a boning channel) so it cannot be easily removed unless you take scissors and cut it.
There’s also a black satin modesty placket extending from the knob side of the busk ( 1/2″ wide).
|Busk||13” long, with 5 loops and pins (last two are a bit closer together). It’s just under an inch wide on each side (so slightly wider than a standard busk, and also very slightly stiffer).|
|Boning||14 bones total in this corset. On each side, 5 of them are spirals about ¼ inch wide – single boned on the seams. There are also two flat steel bones, both ¼” wide sandwiching the grommets on each side.|
|Grommets||There are 24, two-part size #00 grommets (12 on each side). They have a medium flange and are finished in silver. They’re spaced equidistantly about 1” apart. However the grommets are pulling out of the fabric at the waistline.|
|Laces||The laces are 3/8” wide flat nylon shoe-lace style. I find them to be long enough, and they hold bows and knots well. A little springy but it “stretches out” and the springiness goes away over time.|
|Price||Available in waist sizes 20″ to 38″ in black satin.
£95 GBP on Corsets UK, or $145 on Corset Story.
It’s been several years since I reviewed any piece from Corsets-UK, because I had purchased about 10 of them in the past (between the years of 2010 and 2012) and I was not the most thrilled with their quality. The company approached me in the summer of 2016, letting me know that they had been working hard on creating new curvier designs, with better quality materials, and asked if I would be willing to try a couple of their pieces in exchange for personal feedback. I agreed, and I was surprised to see how much their products have changed over the years. I even took a peek at their steel bones, and noted that their spirals were a thicker gauge and had a shiny galvanized finish (no rust) and although there were small holes in the flat steels, they were properly dipped, had no rust or sharp points, and had a decent amount of flex to them.
The two issues I had with the corset were the oddly high placement of the waist tape, which seemed to not coincide with the smallest waist measurement of the corset (the place of highest tension), and the grommets that had started to pull away from the fabric at the waistline. I alerted them to this by email, and their representative said that they are happy with their products and saw no reason to change these. While it was not in the original agreement to review this corset (and the other two coming up soon) publicly, I did ask them if it was alright to share the review with my viewers / readers, bearing in mind that it will be a balanced review where I mention the good points and the room for improvement. They agreed, so here we are.
I’m wearing the corset laced closed here, but the website states that their corsets should be worn with a 2-inch gap in the back. I would not recommend this style of corset for training down – not only because it’s an overbust, which is already tricky to train in – but also because the fit of this corset is crucial for the hip panels to be properly situated at each side of the body. If the corset is too small for you, the hip panels will be positioned too far forward and may not fit over your own hips, which would look odd and feel uncomfortable. Using this corset for fashion purposes and ensuring that it fits with small gap in the back (laced closed, up to perhaps a maximum of 3 inches in the back), will make sure the corset fits the way it should. So if you are between sizes, I would recommend going up a size – especially if you are fuller in the bust.